To ensure an effective DNA isolation from nail clippings, the

lysis buffer of QIAamp® DNA Mini Kit was exchanged by the buffers L, N and proteinase K which were part of the multiplex PCR kit and applied as described by the manufacturer (Biotype Diagnostic GmbH, Dresden, Germany). Purified DNA from fungal cultures was quantified via UV–VIS spectrometry using a NanoDrop® ND-1000 (PEQLAB Biotechnologie GmbH, Erlangen, Germany). PCR was performed with Mentype® MycodermQS PCR Amplification Kit (Biotype Diagnostic) according to the instructions of the manufacturer. Briefly, Selleck Ensartinib the kit consists of all reagents to perform two separate multiplex PCRs (Table 2 and Fig. 1). Primer mix 1 contains specific PCR primer pairs for E. floccosum, M. canis,

Microsporum gypseum, Trichosporon cutaneum, S. brevicaulis, Aspergillus spp., Candida spp. and an unrelated internal amplification control (QS, quality sensor). Primer mix 2 supplies specific PCR primer pairs for the amplification of T. rubrum, T. interdigitale, Trichophyton spp. and QS. The calculated amplicon size of QS is 1231 bp. Aliquots of 7 or 4 μl purified DNA solution from clinical samples were applied to PCR 1 or PCR 2, respectively, in a final volume of 25 μl. The thermocyclers GeneAmp 9700 (Applied Biosystems Deutschland GmbH, Darmstadt, Germany), Eppendorf Mastercycler ep-S (Eppendorf PXD101 supplier AG, Hamburg,

Germany) and Biometra T1 (Biometra GmbH, Göttingen, Germany) were used for analytical validation. The enzyme reaction consisted of 4 min at 96 °C followed by five cycles of 30 s at 94 °C, 60 s at 62 °C and 90 s at 72 °C, and 35 cycles of 30 s at 94 °C, 60 s at 60 °C for 60 s and 90 s at 72 °C. Dermatophyte-specific PCR results were partially confirmed by PCR second with alternative primer pairs as described.[1, 20-22] After PCR, 10 μl was mixed with 2 μl sixfold gel-loading buffer (Applichem GmbH, Darmstadt, Germany) and subjected to 2% agarose gel electrophoresis in onefold TBE-buffer using the iMupid Mini Agarose Gel Electrophoresis System (Helixx Technologies Inc., Toronto, ON, Canada) at 100 V until the bromphenol marker reached the end of the 7 cm isolating distance. The gel was stained for 20 min with GelRed™ (Biotium Inc., Hayward, CA, USA) and analysed with the gel documentation system BioVision 3000 (Vilber Lourmat Deutschland GmbH, Eberhardzell, Germany) equipped with a 312-nm UV light source, a 590-nm emission filter and the software Bio1D. The PCR kit is provided with reference ladders for PCR 1 and 2, respectively, which were applied in separate wells in electrophoresis and used as size standards for gel analysis (Fig. 1 and Fig. 2).